|Date Added:||7 August 2008|
|File Size:||17.24 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Handle the film by the edges so as not to get fingerprints on it. Raise the plotter’s carriage cover. This includes both the stripe and the white dots on either side. If the calibration fails, the message Calibration failed will display. Plotter parts have been changed pinch wheels, for example. How does HP install software and gather data? Load a sheet of E draftmatser D size polyester film in the plotter. If it does not have a paper cutter, use a sharp blade or another cutting device.
When ax calibration procedure is complete, the message Calibration complete will display.
C Draftmaster SX Pen Plotter | eBay
The pen holder will move across the platen. When reloading polyester film, place the writing surface face up; make sure the left pinch wheel is correctly aligned with the left edge of the plotting media.
Turn the plotter off and then on again before plotting. The Virtual Agent is currently unavailable. draftnaster
HP DraftMaster SX, RX, MX, SX Plus, RX Plus, MX Plus plotters – Internal Demo Plots
Make sure the pen is in good operating condition and has a tip size of 0. See your browser’s documentation for specific instructions.
Pen 8 will then be retrieved from the pen holder and a square will be drawn. Carefully align the line on the left pinchwheel with the left edge of the media.
HP Computer Museum
The plotting environment differs considerably from the calibration environment at the factory 18 to 30 degrees C, level floor. Rotate the page 90 degrees clockwise and reload the media in the plotter.
HP DraftMaster I, II, SX, RX and MX Plotters – Plotter Calibration
The message Calibrating will display. The plotter is calibrated at the factory using E-size AO polyester film and a black drafting pen. Additionally, verify that the white stripe on the platen is clean.